Description
Our Angle Pegs are ideally suited to lock up formwork bottom board corners and adjacent sides of a drop edge beam corners because more than one screw can be installed to each board at the intersection. The pegs can also be used to form up profiles because the hole spacing provides an opportunity to install 2 screws into most boards, locking its location.
The point on the Angle peg is blunted for safety reasons as well as to provide more bearing for the post as it is driven into the ground.
The design registered design features a raised impact zone on the peg cap directly over the peg corner which supports hammer impacts without damaging the unsupported flanges.
They come in 50×50 x 4 mm angle with closely spaced holes and when used in conjunction with the DEF1000 provides support for the outrigger end, the junction between the outrigger and the lower board, and when driven against and in line with the outrigger at 45degrees, bracing for the drop edge beams.
Our range of powder-coated Angle Pegs come in two lengths, 900mm and 1350mm
Price including GST.
